Setup / FAQ
No, since all of the functionality of these PROMs (and more!) is now in the EurekaPROM 3.
All configurations with the possible exception of PP-Programmable use MIDI Channel 1 only. It is possible to access all 16 MIDI channels from the PP-Programmable configuration.
Each configuration has its own. Moving between configurations will NOT erase the Favorite Preset values.
Version 3.2.
The labels are manufactured and printed in the United States. The EPROM is programmed in the United states. The EPROM is of international origin.
The EurekaPROM is shipped via USPS First Class Mail, in a 6"x9" bubble envelope. The envelope contains the EurekaPROM and the labels.
Yes, you can perform a Diagnostic Routine that allows you to verify the hardware components of the EurekaPROM-enabled FCB1010, including: LEDs, the 7-segment display, the expression pedals, and the MIDI connectors.
To execute diagnostics:
Connect a MIDI cable from the FCB1010 MIDI output to the FCB1010 MIDI input.
Hold down pedals 1 and 0 while powering up the unit.
Diagnostics testing will begin.
All LED's will toggle on/off in sequence
All segments of the 7-segment display will be tested.
MIDI Loopback will be performed. If this fails (cable not attached), the display will show "IO" then stop.
Pedal testing mode. Pressing a pedal will turn its corresponding led on/off. Pressing the expression pedal will show the value on the 7-segment display. Pressing up/down will switch which expression pedal is displayed on the 7-segment display.
The FCB-1010 needs to be power cycled to exit from Diagnostics mode.
Yes. Hold down pedals 1 & 9 while powering on. That will clear all data stored in the FCB1010.
MIDI thru is supported in the following configurations: 11, G-, Po, bo, PP.
Have more questions? Check our Forum, or Contact us!